Τhis is Multi PIC Programmer 5 Ver.2 it is also called “JDM programmer”.It can program 8 pin to 40 pin DIP package PIC microcontrollers.It is very cheap ,easy to build and does not require any external power supply .
Below my tutorial you can find a zip file for Circuit diagram , PCB Layout , Component position and all essential information.
Before connecting this programmer with your computer please check the connection once again because it may damage your computer permanently and it may not work properly with USB to serial converter .
FEW STEPS TO MAKE PCB
At first print the circuit diagram on a glossy paper and cut the PCB according to the size of layout.
Flat this paper on the PCB and use sticky tape to attach it.
Start ironing .Try to set the iron in cotton mood.
Allow the PCB plate to cool down and Put it inside the water
After 10 minute slowly remove the paper
Now fill the broken lines with a permanent marker
Dip the PCB into the Etching solution of Ferric chloride ( Fecl3)
When unwanted copper removed wash this board with water and remove the black spots of ink.
Now drill the PCB using a drill machine
Place the jumper wires first
place zif socket and db9 connector and Done
TIME TO PROGRAMME
Now install winpicpgm_220.127.116.11.exe
Run the software
Connect the programmer with computer
Click on Autodetect PIC button
After that Programmer and Microcontroller will be detected
Choose hex file and press Programme pic and Programme will burn successfully.